
Collapsible content
Description
Radium Dual Fluid Lock Catch Can Kit, Nissan S15 200SX / Silvia (SR20DET)
Suits: Nissan S15 200SX and Silvia, SR20DET
Part Number: 20-0637-FL
This is Radium's recommended setup for the S15: the PCV kit (20-0635-FL) and CCV kit (20-0636-FL) together. The PCV can sits on three factory bosses in the right-hand corner near the firewall and catches what manifold vacuum draws in at idle, cruise and on decel. The CCV can mounts on the wiper motor mounts and catches the oil the crankcase vent pushes into the intake pipe and intercooler under boost.
It's a closed-loop system with nothing vented to atmosphere, and both cans are pressure sealed so no check valve is needed. Both bolt in with no drilling.
Pairs Well With
- Radium Catch Can Petcock Drain Kit (20-0024)
- Radium Catch Can O-Ring Service Kit (20-0057)
- Radium Fuel Pump Hanger, S14 / S15 / R33 / R34
Good to Know
- No extra inline check valve needed. Radium cans are pressure sealed
- There's no fixed emptying interval. Check the dipsticks after 3–4 weeks and adjust from there. The PCV can usually fills faster than the CCV can
- Collecting a lot of oil can point to high blow-by, an overfilled sump, poor breather placement or a PCV valve not sealing under load
Vehicle Fitment
- Nissan 200SX S15
- Nissan Silvia S15
Genuine Radium Engineering, stocked in Somersby NSW and shipped Australia-wide by the official Australian distributor. Not sure it suits your car? Email sales@radiumengineering.com.au and we'll confirm fitment.