
Collapsible content
Description
Radium MPR RA Multi-Port Fuel Pressure Regulator
Suits: Universal, port-injection EFI systems running 20–150 psi
Part Number: 20-1100-00 (black), 20-1100-01 (green)
The MPR is the go-to Radium regulator for single and multi-pump setups. With three feed ports and two opposing returns, you can plumb it flow-through or dead-head without a separate Y fitting, and the lines can run wherever suits the engine bay.
Pressure is set with the RA-series tool-less knob. It mounts to a wall through the M6 holes in the body, or to the floor with the included bracket.
Pairs Well With
- Radium FPR Service Diaphragm (18-0017)
- Radium FPR Wide Range Spring (18-0046)
- Radium Fuel Pressure Gauge with 6AN Inline Adapter (20-0152)
Good to Know
- Minimum pressure is 1.3 bar (18.5 psi). Maximum depends on your pump setup
- Plug unused ports (plugs included)
- Use medium-strength wicking thread locker on the vacuum fitting, and don't over-torque it
- Pressure dropping quickly after shut-off is normal. Long cranking points to feed line drain-back, not the regulator
Vehicle Fitment
- Universal, any port-injection EFI fuel system running 20–150 psi
Genuine Radium Engineering, stocked in Somersby NSW and shipped Australia-wide by the official Australian distributor. Not sure it suits your build? Email sales@radiumengineering.com.au and we'll confirm fitment.