
Collapsible content
Description
Radium Dual Fluid Lock Catch Can Kit, Nissan 350Z / Skyline V35 / Infiniti G35
Suits: Nissan Skyline V35 and Infiniti G35 (Radium's listed fitment), Nissan 350Z Z33 (confirm with us)
Part Number: 20-0729-FL
This kit puts a PCV can and a CCV can together on one Nissan-specific bracket at the front left of the engine bay. The PCV can catches the vapour and sludge drawn into the manifold at idle, cruise and on decel. The CCV can catches the heavier crankcase flow under full throttle, between the crankcase vent and the intake pipe.
Both cans are pressure sealed, so no extra check valve is needed. Both use Radium's patented 207ml Fluid Lock design, which can't overfill.
Pairs Well With
- Radium Fluid Lock PCV Catch Can Kit, 350Z / V35 VQ35DE (20-0728-FL)
- Radium Catch Can Petcock Drain Kit (20-0024)
- Radium Catch Can O-Ring Service Kit (20-0057)
Good to Know
- Doesn't work with the factory Nissan airbox, so an aftermarket intake is needed
- Radium's compatibility list only names the V35 Skyline and G35 (excluding VQ35HR), but its install instructions also cover the 350Z and VQ35HR. Email us to confirm before ordering, especially for a Z33 or VQ35HR
- Radium's instructions say some RHD VQ35HR engines need the bonnet switch dealt with, and some LHD VQ35HR engines need two earth points moved
- A throttle re-learn may be needed after fitting
- There's no fixed emptying interval. Check the dipsticks from 3–4 weeks. The PCV can usually collects more than the CCV can
- Collecting a lot of oil can point to blow-by, overfilled oil, poor breather baffling or a PCV valve leaking under load
Vehicle Fitment
- Nissan Skyline (V35)
- Infiniti G35 (V35)
- Nissan 350Z / Fairlady Z (Z33): covered in Radium's install instructions but not on its compatibility list. Confirm with us
Genuine Radium Engineering, stocked in Somersby NSW and shipped Australia-wide by the official Australian distributor. Not sure it suits your car? Email sales@radiumengineering.com.au and we'll confirm fitment.