
Collapsible content
Description
Radium DIY Fuel Pump Hard Wiring Kit
Suits: Universal, one fuel pump or other high-current device
Part Number: 17-0031
Everything you need to build a dedicated relay and fuse power circuit for one fuel pump. It's a common job when upgrading to a bigger pump or E85, where the factory wiring can't supply enough current. The relay and fuse holder are sealed for weather-exposed spots, the 10AWG TXL wire resists heat and chemicals, and crimpless solder heat-shrink splices make the joins.
Pairs Well With
Good to Know
- Radium recommends a dedicated fuse and relay for each pump, so order one kit per pump
- The relay trigger can be wired to ground or a 12V signal, as long as the other end of the relay coil goes to the opposite source
- Installation instructions are on the Instructions tab
Vehicle Fitment
- Universal
Genuine Radium Engineering, stocked in Somersby NSW and shipped Australia-wide by the official Australian distributor. Not sure it suits your build? Email sales@radiumengineering.com.au and we'll confirm fitment.